Light Meter Pod
The Light Meter Pod is supplied with the MLT331 Light Meter Probe and is used for monitoring light intensity (200 lux - 200 klux). The Pod and Probe are not intended for any clinical or diagnostic use. The Light Meter Pod connects to any PowerLab hardware units with Pod ports (8-pin DIN inputs). PowerLab and units without Pod ports require the FE305 Pod Expander.
The MLT331 Light Meter Probe is a fast response, directional specific, visible light meter probe. It contains a fast response silicon photodiode that is active in the visible region of the RF spectrum, and produces a voltage that is proportional to the logarithm of the incident light intensity. The probe is fitted with a BNC connector. It is used with the ML330 Light Meter Pod.
The Light Meter Pod is supplied with the MLT331 Light Meter Probe and is used for monitoring light intensity (200 lux - 200 klux). The Pod and Probe are not intended for any clinical or diagnostic use. The Light Meter Pod connects to any PowerLab hardware units with Pod ports (8-pin DIN inputs). PowerLab units without Pod ports require the FE305 Pod Expander.
- Monitoring low and high light levels
- Changes from daylight
- Room lights
- Measuring light intensity through solutions
The MLT331 Light Meter Probe is a fast response, directional specific, visible light meter probe. It contains a fast response silicon photodiode that is active in the visible region of the RF spectrum, and produces a voltage that is proportional to the logarithm of the incident light intensity. The probe is fitted with a BNC connector. It is used with the ML330 Light Meter Pod.
The Light Meter Pod is supported by the following versions of LabChart and Scope software:
WINDOWS
- LabChart v3.4.8 or later\
- Scope v3.6.3 or later
MACINTOSH
- LabChart v3.6.3 or later
- Scope v3.6.3 or later
Note: Earlier software versions do not support Pods.
Stacking and Unstacking Pods:
Pods stack by clicking into place on top of each other. To separate stacked Pods, push the top Pod towards the back and then pull them apart from the back.
The MLT331 Light Meter Probe is a fast response, directional specific, visible light meter probe. It contains a fast response silicon photodiode that is active in the visible region of the RF spectrum, and produces a voltage that is proportional to the logarithm of the incident light intensity. The probe is fitted with a BNC connector. It is used with the ML330 Light Meter Pod.
Specifications | 77-0048 | 77-0086 |
---|---|---|
Certifications | CE | *na |
Model | ML330 | MLT331 |
Package | 1 | 1 |
Product Family | Data Acquisition | Data Acquisition |