Large Surface Thermistor Probes
Ideal for cuvette, water bath, skin surface and other flat surface temperature measurements
Time constant 1.1 seconds
Maximum temperature 150°F (302°C)
Many other thermistor probes are available.
Ideal for cuvette, water bath, skin surface and other flat surface temperature measurements. The 9.5 mm (3⁄8 in) diameter by 3.2 mm (1 ⁄8 in) thick sensor disk has a stainless steel patient side and epoxy back. Time constant 1.1 seconds
Two probes are available. The 59-9812 probe has a flat, vinyl covered 3.1 m (10 ft) lead terminating in a 400 series phone jack connector. The 60-2315 has a flat, 305 mm (12 in) PTFE coated lead connected to a 3.1 m (10 ft) vinyl covered lead with a 400 series phone jack connector.
The adhesive patches are for holding skin surface temperature probes securely against skin for good thermal conductivity. Minimizes distortion of probe readings. Hypo-allergenic medical grade adhesive.
Item# | 59-9812 |
Interchangeability Tolerance |
±0.1oC over biological range from 32o to 42oC |
Lead Length | 3.1 m (10 ft) |
Lead Thickness | 1.3 mm (0.05 in) |
Lead Width | 3.4 mm (0.13 in) |
Maximum Temperature | 150oC (302oF) |
Minimum Temperature | -40oC (-40oF) |
Probe Wire Isolation | Isolated |
Sensor Disk Diameter | 9.5 mm (0.375 in) |
Sensor Disk Material | Stainless Steel and Epoxy sides |
Sensor Disk Thickness | 3.2 mm (0.125 in) |
Shaft Length | 254 mm (10 in) |
Shaft Material | Vinyl |
Time Constant | 1.1 seconds |